Rohde & Schwarz R&S ZNA Series - 5.2.4.3 Harmonics measurements

GUI reference
R&S
®
ZNA
365User Manual 1178.6462.02 ─ 29
Use Generator as Source
If selected, the "Port" control lists the external generators. Otherwise it lists the ana-
lyzer ports.
External generators must be configured explicitly in the "External Generators" dialog
before they appear in the list. See also Chapter 4.7.40, "External generators",
on page 321.
Port
Allows you to select the source for the stimulus signal.
●
"None", "Port <Pt>", or "Conv <Pt>", if Use Generator as Source is not checked
●
"Gen <i>" if "Use Generator as Source" is checked
Remote command:
CALCulate<Ch>:PARameter:MEASure "<Trace_Name>", "<Ratio>"
CALCulate<Ch>:PARameter:SDEFine "<Trace_Name>", "<Ratio>"
Detector
Selects the algorithm that is used to calculate the results points from the raw measure-
ment data.
For details refer to Chapter 4.3.5.3, "Detector settings", on page 160.
Remote command:
CALCulate<Ch>:PARameter:MEASure
CALCulate<Ch>:PARameter:SDEFine
[SENSe<Ch>:]SWEep:DETector:TIME
5.2.4.3 Harmonics measurements
Harmonics measurements require option R&S ZNA-K4, see (Chapter 4.7.3.4, "Scalar
mixer measurements", on page 271).
"More Harmonics..." opens the More Harmonics dialog that allows you to select from
the full range of direct and relative harmonics measurements.
"Wave Correction" applies to wave quantitiy, ratio and harmonics measurements. The
corresponding checkbox is also shown on the "Wave" tab (see "Wave Correction"
on page 359).
b2 2nd Harmonic Src Port 1
Power of the outgoing wave at port 2, measured at 2 times the frequency of the wave
generated at port 1.
Meas softtool