GUI reference
R&S
®
ZNA
637User Manual 1178.6462.02 ─ 29
Manage Cals – Cal Manager...
Opens the Calibration Manager dialog
Manage Cals – Remove all Cal Data
This button cleans the active channel's existing calibration data and also removes links
to the calibration pool.
Remote command:
[SENSe<Ch>:]CORRection:DELete
Manage Cals – Join Calibration...
Opens the JoinCal dialog
5.11.4.2 Active Power Cals dialog
The "Active Power Cals" dialog shows the power calibrations that are compatible with
the active channel configuration. It allows you to enable or disable the available power
calibrations.
Access: Channel – [Cal] > "Use Cal" > "Active Power Cals..."
All possible power calibrations can be performed from the Power Cal wizard.
Port Overview
Shows all source ports together with their possible power calibrations. Unavailable cali-
brations (i.e. calibrations that have not been performed yet) are grayed out.
If external generators are configured, they appear as additional source ports G1 ... Gm
in the port overview. A source power calibration is available at each generator port.
If the optional LO Out is equipped and not configured as LO source for millimeter wave
converters, it appears as "C.LO" port with a possible "Source Flatness" cal.
If frequency converters are configured, additional source flatness calibrations can be
performed for the analyzer ports driving the converters' RF IN and LO IN ports.
Cal softtool
To Next Page
Loading...
