GUI reference
R&S
®
ZNA
904User Manual 1178.6462.02 ─ 29
Splitter <i>
The source of the LO signal distributed via splitter <i>.
If two or more converters are used in a measurement, it is recommended to distribute a
single LO signal to all involved converters using a splitter. The corresponding configu-
ration is to select the suitable LO source here and set Local to "Splitter <i>".
"Splitter 2" is only useful, if 2 independent 2-port converter measurements shall be per-
formed.
If compatible with the overall converter setup, the source is automatically configured as
permanent (see "Source Gen" on page 671).
Remote command:
[SENSe:]CONVerter:SPLitter<Port>:LOPort
5.19.6.2 Converter Types dialog
The "Converter Types" dialog displays the configured converter types. Browse through
the tabs to explore their properties.
Access: Converter Configuration dialog > "Converter Types..."
Setup softtool
To Next Page
Loading...
