Rohde & Schwarz R&S ZNA Series - Page 1336

Command reference
R&S
®
ZNA
1336User Manual 1178.6462.02 ─ 29
<LocalIndex> The port index, if required.
For NONe and RLO the index is ignored.
Options: R&S ZNA-K8
Manual operation: See "Local" on page 903
[SENSe:]CONVerter<Port>:RFLoss <Loss>
Defines the cable loss at the source port or converter <Port>.
Suffix:
<Port>
.
Converter port number (= physical VNA port number)
Parameters:
<Loss> Loss value
Default unit: dB
Options: R&S ZNA-K8
Manual operation: See "Cable & Splitter Loss" on page 907
[SENSe:]CONVerter<Port>:RFPort?
Returns the VNA source port that drives converter <Port>.
Always returns <Port>.
Suffix:
<Port>
.
Converter number
Usage: Query only
Options: R&S ZNA-K8
Manual operation: See "Source" on page 903
[SENSe:]CONVerter<Port>:RFSLope <Slope>
Suffix:
<Port>
.
Parameters:
<Slope> Default unit: DB/GHZ
Manual operation: See "Slope" on page 676
[SENSe:]CONVerter:SPLitter<Port>:LOPort <Local>[, <LocalIndex>]
Defines the source of the LO signal distributed via splitter <Port>.
"Splitter 2" is only useful, if 2 independent 2-port converter measurements shall be per-
formed.
SCPI command reference