Rohde & Schwarz R&S ZNA Series - Page 1335

Command reference
R&S
®
ZNA
1335User Manual 1178.6462.02 ─ 29
Suffix:
<Port>
.
Converter number = VNA port number
Parameters:
<IF> Intermediate frequency
Defaults to the intermediate frequency ([SENSe:]CONVerter:
DEFinition:IFRequency on page 1332) of the connected
converter type ([SENSe:]FREQuency:CONVersion:
DEVice<Port>:NAME).
Default unit: Hz
Options: R&S ZNA-K8
Manual operation: See "IF Frequency" on page 903
[SENSe:]CONVerter<Port>:LOLoss <Loss>
Defines the cable loss at port <Port> if used as LO port (without splitter).
Suffix:
<Port>
.
Port number
Parameters:
<Loss> Loss value
Default unit: dB
Options: R&S ZNA-K8
[SENSe:]CONVerter<Port>:LOPort <Local>, <LocalIndex>
Defines the source for the LO In port of converter <Port>.
Suffix:
<Port>
.
Converter number = VNA port number
Parameters:
<Local> NONE | RLO | PORT | GENerator | SPLitter
The port type, further specified by its index <LocalIndex>
NONE
No LO source defined
RLO
The optional LO Out port at the rear panel of the R&S ZNA
PORT
A VNA port
GENerator
An external generator port
SPLitter
A splitter is used to distribute the original LO signal to the LO In
ports of the involved converters
SCPI command reference