Rohde & Schwarz R&S ZNA Series - 5.2.15.2 Two Tone Group Delay setup dialog

GUI reference
R&S
®
ZNA
418User Manual 1178.6462.02 ─ 29
5.2.15.2 Two Tone Group Delay setup dialog
The "Two Tone Group Delay" dialog is an example of a Multi-channel setup dialog. It
allows you to prepare one or more channels for two-tone group delay measurements
(with or without embedded LO).
Access: Trace – [Meas] ("Mixer Params") > "Two Tone Group Dly" > "Setup Fre-
quency Converting DUT"
Lower Tone
Select the port that generates the lower tone of the two-tone signal.
Remote command:
[SENSe<Ch>:]FREQuency:MDELay:LTONe
Upper Tone
Select the port that generates the upper tone of the two-tone signal.
Remote command:
[SENSe<Ch>:]FREQuency:MDELay:UTONe
Combiner Configuration
See Combiner Configuration.
IF
Select the receive port for the two-tone group delay measurement.
Meas softtool