Rohde & Schwarz R&S ZNA Series - Page 1667

Command reference
R&S
®
ZNA
1667User Manual 1178.6462.02 ─ 29
[SENSe<Ch>:]FREQuency:MDELay:CORRection[:STATe] <arg0>
Qualifies whether the analyzer applies the current mixer delay measurement calibra-
tion data.
Tip:
The analyzer automatically applies the calibration data when a calibration file is loaded
(MMEMory:LOAD:MDCData) or after a calibration sweep has been completed
([SENSe<Ch>:]FREQuency:MDELay:ACQuire).
Suffix:
<Ch>
.
Channel number.
Parameters:
<arg0> ON | OFF – Apply / ignore calibration data
*RST: OFF
Example: See MMEMory:LOAD:MDCData on page 1290
[SENSe<Ch>:]FREQuency:MDELay:DIVide <Group Delay Divide by 2 flag>
Suffix:
<Ch>
.
Parameters:
<Group Delay Divide
by 2 flag>
[SENSe<Ch>:]FREQuency:MDELay:LTONe <lower tone port number>
Suffix:
<Ch>
.
Parameters:
<lower tone port
number>
Manual operation: See "Lower Tone" on page 418
[SENSe<Chn>:]FREQuency:MDELay:MSTate?
Suffix:
<Chn>
.
Usage: Query only
[SENSe<Ch>:]FREQuency:MDELay:RECeiver <Group Delay Receiver Mode>
Suffix:
<Ch>
.
SCPI command reference