Rohde & Schwarz R&S ZNA Series - Page 1666

Command reference
R&S
®
ZNA
1666User Manual 1178.6462.02 ─ 29
[SENSe<Ch>:]FREQuency:MDELay:CDELay <const delay value for ref mixer>
Defines a constant mixer delay value, to be used as a reference for a mixer delay mea-
surement calibration. The setting takes effect after constant mixer delay is enabled;
see example below.
Suffix:
<Ch>
.
Channel number
Parameters:
<const delay value for
ref mixer>
Constant delay
Range: 0 to 1 ms
*RST: 0
Default unit: s
Example:
*RST; :FREQ:MDEL:CDEL 1 ns
Define a constant mixer delay value of 1 ns.
MMEM:LOAD:MDAD 1, CDEL
Use constant delay value for mixer delay measurement calibra-
tion.
Manual operation: See "Constant Cal Delay" on page 592
[SENSe<Ch>:]FREQuency:MDELay:CDMode <arg0>
Suffix:
<Ch>
.
Parameters:
<arg0>
Manual operation: See "Use Constant Cal Delay" on page 592
[SENSe<Ch>:]FREQuency:MDELay:CONVersion <Mixer delay conversion flag>
Disables the mixer delay measurement and switches back to normal (non frequency-
converting) mode.
Suffix:
<Ch>
.
Channel number
Setting parameters:
<Mixer delay
conversion flag>
OFF
Disable mixer delay measurement
*RST: OFF
Example: See [SENSe<Ch>:]FREQuency:MDELay:APERture
on page 1665
Usage: Setting only
Manual operation: See "Apply/OK" on page 419
SCPI command reference