Rohde & Schwarz R&S ZNA Series - 7.3.16 STATus commands

Command reference
R&S
®
ZNA
1601User Manual 1178.6462.02 ─ 29
Manual operation: See "Receiver Input" on page 678
7.3.16 STATus commands
The STATus:... commands control the status reporting system. Status registers are
not reset by *RST; use *CLS for this purpose.
STATus:PRESet...........................................................................................................1601
STATus:QUEStionable:CONDition?................................................................................1602
STATus:QUEStionable:INTegrity:CONDition?..................................................................1602
STATus:QUEStionable:INTegrity:HARDware:CONDition?.................................................1602
STATus:QUEStionable:LIMit<Lev>:CONDition?...............................................................1602
STATus:QUEStionable:ENABle..................................................................................... 1602
STATus:QUEStionable:INTegrity:ENABle........................................................................1602
STATus:QUEStionable:INTegrity:HARDware:ENABle.......................................................1602
STATus:QUEStionable:LIMit<Lev>:ENABle.....................................................................1602
STATus:QUEStionable[:EVENt]?....................................................................................1602
STATus:QUEStionable:INTegrity[:EVENt]?......................................................................1602
STATus:QUEStionable:INTegrity:HARDware[:EVENt]?.....................................................1602
STATus:QUEStionable:LIMit<Lev>[:EVENt]?...................................................................1602
STATus:QUEStionable:NTRansition...............................................................................1603
STATus:QUEStionable:INTegrity:NTRansition................................................................. 1603
STATus:QUEStionable:INTegrity:HARDware:NTRansition................................................ 1603
STATus:QUEStionable:LIMit<Lev>:NTRansition.............................................................. 1603
STATus:QUEStionable:PTRansition............................................................................... 1603
STATus:QUEStionable:INTegrity:PTRansition................................................................. 1603
STATus:QUEStionable:INTegrity:HARDware:PTRansition................................................ 1603
STATus:QUEStionable:LIMit<Lev>:PTRansition.............................................................. 1603
STATus:QUEue[:NEXT]?.............................................................................................. 1604
STATus:PRESet
Configures the status reporting system such that device-dependent events are repor-
ted at a higher level.
The command affects only the transition filter registers, the ENABle registers, and
queue enabling:
●
The ENABle parts of the STATus:OPERation and STATus:QUEStionable... reg-
isters are set to all 1's.
●
The PTRansition parts are set all 1's, the NTRansition parts are set to all 0's,
so that only positive transitions in the CONDition part are recognized.
The status reporting system is also affected by other commands, see Chapter 6.5.5,
"Reset values of the status reporting system", on page 966.
Example:
STAT:PRES
Preset the status registers.
Usage: Event
SCPI command reference