Rohde & Schwarz R&S ZNA Series - Page 1602

Command reference
R&S
®
ZNA
1602User Manual 1178.6462.02 ─ 29
STATus:QUEStionable:CONDition?
STATus:QUEStionable:INTegrity:CONDition?
STATus:QUEStionable:INTegrity:HARDware:CONDition?
STATus:QUEStionable:LIMit<Lev>:CONDition?
Returns the contents of the CONDition part of the QUEStionable... registers.
Reading the CONDition registers is nondestructive.
Suffix:
<Lev>
.
Selects one of the two QUEStionable:LIMit registers; see
"STATus:QUEStionable:LIMit<1|2>" on page 960.
Example:
STAT:QUES:LIMit:COND?
Query the CONDition part of the QUEStionable:LIMit1 reg-
ister to retrieve the current status of the limit check.
Usage: Query only
STATus:QUEStionable:ENABle <BitPattern>
STATus:QUEStionable:INTegrity:ENABle <BitPattern>
STATus:QUEStionable:INTegrity:HARDware:ENABle <BitPattern>
STATus:QUEStionable:LIMit<Lev>:ENABle <BitPattern>
Sets the enable mask which allows true conditions in the EVENt part of the
QUEStionable... registers to be reported in the summary bit. If a bit is 1 in the
enable register and its associated event bit transitions to true, a positive transition will
occur in the summary bit (e.g. bit 10 of the QUEStionable register for the LIMit1
register, bit 0 of the LIMit1 register for the LIMit2 register).
See also Chapter 6.5.1, "Overview of status registers", on page 954 and Chapter 6.5.5,
"Reset values of the status reporting system", on page 966.
Suffix:
<Lev>
.
Selects one of the two QUEStionable:LIMit registers; see
"STATus:QUEStionable:LIMit<1|2>" on page 960.
Parameters:
<BitPattern> Range: 0 to 65535 (decimal representation)
*RST: n/a
Example:
STAT:QUES:LIM2:ENAB 6
Set bits no. 1 and 2 of the QUEStionable:LIMit2:ENABle
register
STATus:QUEStionable[:EVENt]?
STATus:QUEStionable:INTegrity[:EVENt]?
STATus:QUEStionable:INTegrity:HARDware[:EVENt]?
STATus:QUEStionable:LIMit<Lev>[:EVENt]?
These commands return the contents of the EVENt parts of the QUEStionable,
QUEStionable:INTegrity, QUEStionable:INTegrity:HARDware, and
QUEStionable:LIMit<Lev> status registers. Reading an EVENt register clears it.
SCPI command reference