GUI reference
R&S
®
ZNA
773User Manual 1178.6462.02 ─ 29
5.15.1.1 Basic Recall Set functions
To create a recall set based on the current analyzer configuration, select Save. To
open an existing recall set, select Open Recall.... To create an additional setup, select
New.
The R&S ZNA supports two recall set file formats:
●
znxml (default)
XML based file format, introduced with the R&S ZNA
●
znx
Binary file format, originating from the R&S ZNB
New
Adds a new setup. The default names for new setups are "Set1", "Set2" etc. Recall
sets are accessible via tabs in the diagram area:
Tip: To open an existing recall set, use "Open Recall...". To rename a setup, use
"Save...".
Remote command:
MEMory:DEFine
Open Recall...
Loads a recall set from a file (*.znxml|*.znx).
Opens the Open Dialog with suitable file filters.
If the current setup includes External switch matrices and the recall set to be loaded
does not contain a switch matrix configuration, recalling the setup is aborted. You are
requested to delete the configured RF connections (see Chapter 5.19.7.4, "Switch
Matrix RF Connections dialog", on page 914) and to remove the switch matrix from
the RF paths.
If the recall set to be loaded contains a switch matrix configuration and no differences
to the current switch matrix configuration are detected, the recall set is loaded without
further inquiry. Otherwise you are asked if you want to adapt the configuration:
File Print softtool
To Next Page
Loading...
