GUI reference
R&S
®
ZNA
605User Manual 1178.6462.02 ─ 29
left = "Ref. Receiver" Pwr Cal Method
right = "Power Meter" Pwr Cal Method
Start Cal Sweep
Start the calibration sweeps for the selected port and power calibration settings and
close the dialog. The calibration is performed as described in "Calibration procedure"
on page 220.
Use the Pwr Cal Settings tab"Pwr Cal Settings" to modify the calibration procedure.
Remote command:
SOURce<Ch>:POWer:CORRection[:ACQuire]
SOURce<Ch>:POWer<PhyPt>:CORRection:COLLect[:ACQuire]
5.11.1.6 Calibrate All dialog
The "Calibrate All" dialog guides you through the setup of complex calibration scenar-
ios, where the set of calibrations to be performed for each port group and channel is
freely configurable. The calibration configuration is persisted and can be recalled.
Background and related information
See Chapter 4.5.8, "Parallel calibration of multiple channels", on page 227.
Access: Channel – [Cal] > "Start Cal" > "Calibrate All" – "Configure + Start..."
Cal softtool
To Next Page
Loading...
