Rohde & Schwarz R&S ZNA Series - HUMS tab; Common controls

GUI reference
R&S
®
ZNA
871User Manual 1178.6462.02 ─ 29
HUMS tab
The "HUMS" tab allows you to enable and configure R&S HUMS (see Chapter 4.7.19,
"Health and usage monitoring service (HUMS)", on page 301). It is only available if
software option R&S ZNA-K980 is installed.
Common controls
State (Device Utilization)/Status
Enables/disables the HUMS service.
The "Status" LED indicates the current state of the HUMS service:
●
grey: inactive
●
green: up and runnning
If HUMS has been used before, turning on restores the previous protocol settings.
Remote command:
DIAGnostic:HUMS:STATe
REST ← State (Device Utilization)/Status
Enables/disables the REST interface to the HUMS service.
Remote command:
SYSTem:COMMunicate:REST:ENABle
SNMP ← State (Device Utilization)/Status
Enables/disables the SNMP interface to the HUMS service and allwos you to select the
supported SNMP protocol versions.
Setup softtool