Rohde & Schwarz R&S ZNA Series - [SENSE:]NFIGure... (other)

Command reference
R&S
®
ZNA
1452User Manual 1178.6462.02 ─ 29
[SENSe<Ch>:]NFIGure:QSET:DUT:GAIN <Expected DUT Gain>
Suffix:
<Ch>
.
Parameters:
<Expected DUT
Gain>
Default unit: dB
Manual operation: See "DUT Settings" on page 377
[SENSe<Ch>:]NFIGure:QSET:DUT:POWer
<Maximum desired DUT input power>
Suffix:
<Ch>
.
Parameters:
<Maximum desired
DUT input power>
Default unit: dBm
Manual operation: See "DUT Settings" on page 377
[SENSe<Ch>:]NFIGure:QSET:TNOise <Desired maximum Trace Noise>
Suffix:
<Ch>
.
Parameters:
<Desired maximum
Trace Noise>
Default unit: dB
Manual operation: See "Result Settings" on page 377
[SENSe<Ch>:]NFIGure:QSET[:EXEC]
Suffix:
<Ch>
.
Return values:
<Expected Times>
Manual operation: See "Apply/OK" on page 379
[SENSE:]NFIGure... (other)
[SENSe<Ch>:]NFIGure:CALibration:GTIMe....................................................................1453
[SENSe<Ch>:]NFIGure:CALibration:NTIMe.................................................................... 1453
[SENSe<Ch>:]NFIGure:DEFine.....................................................................................1453
[SENSe<Ch>:]NFIGure:GTIMe......................................................................................1454
[SENSe<Ch>:]NFIGure:HARMonic[:MAXFrequency]....................................................... 1454
[SENSe<Ch>:]NFIGure:HARMonic[:MINFrequency]........................................................ 1454
[SENSe<Ch>:]NFIGure:HARMonic[:MAXimumorder]....................................................... 1455
[SENSe<Ch>:]NFIGure:HARMonic[:STATe].................................................................... 1455
SCPI command reference