Rohde & Schwarz R&S ZNA Series - 5.19.2 Freq. Ref. tab

GUI reference
R&S
®
ZNA
886User Manual 1178.6462.02 ─ 29
Password
Enter a password here to activate the required service level.
Remote command:
SYSTem:PASSword[:CENable]
Service Function
Identifier of the service function in "dotted textual" (example: sw.common.mem-
ory_usage) or "dotted decimal" (example: 0.1.18.0) representation.
Remote command:
DIAGnostic:SERVice:SFUNction
5.19.2 Freq. Ref. tab
Selects a reference signal for synchronization between the R&S ZNA and external
devices. A common reference frequency is advisable to ensure frequency accuracy
and frequency stability in the test setup.
Reference Source
Selects the internal or an external reference clock signal for synchronization.
"Internal"
The analyzer synchronizes to its internal reference oscillator.
The synchronized internal 10 MHz reference clock is also made avail-
able at the rear panel Reference Out BNC connector. In addition, a
synchronized 100 MHz reference signal can be provided at the Refer-
ence In/Out SMA connector (see "Reference I/O (SMA) > Out"
on page 887). Use these signals to synchronize other devices.
Setup softtool