GUI reference
R&S
®
ZNA
380User Manual 1178.6462.02 ─ 29
5.2.6 Intermodulation tab
Allows you to set up the channel for an intermodulation measurement, and to select
intermodulation products and other results as measured quantities.
Intermodulation measurements require software option R&S ZNA-K4. They are availa-
ble for both non-frequency converting and frequency converting DUTs.
Background information
Refer to the following sections:
●
Chapter 4.7.3.2, "Intermodulation measurements", on page 262
●
"Intermodulation quantities" on page 269
The labels for the intermodulation quantities in the trace list are identical to the param-
eters used for remote control; see CALCulate<Ch>:PARameter:SDEFine.
5.2.6.1 Controls on the Intermodulation tab
After a [Preset], most of the controls on the "Intermodulation" tab are disabled. They
are enabled after the current channel has been set up for an intermodulation measure-
ment (see "Intermod" on page 381).
If external switch matrices are used, intermodulation measurements are not supported
and hence the controls on this tab are disabled.
Meas softtool
To Next Page
Loading...
