GUI reference
R&S
®
ZNA
722User Manual 1178.6462.02 ─ 29
Table 5-8: Direct Compensation data
Prompt for Each Port File Type Description
disabled csv One csv trace file per standard,
containing reflection traces for all
selected ports; see Chap-
ter 4.4.2.2, "ASCII (*.csv) files",
on page 184
enabled s1p One 1-port Touchstone file per
standard and port (see Chap-
ter 4.4.2.1, "Touchstone files",
on page 177)
Tip: Remote control provides additional flexibility. You can:
●
Measure the same ports repeatedly without changing the standards and attribute
the results to different channels.
●
Calculate the compensation data for different ports, using mixed Open and Short
standards.
Refer to the program example for [SENSe<Ch>:]CORRection:COLLect:
FIXTure[:ACQuire].
Remote command:
[SENSe<Ch>:]CORRection:COLLect:FIXTure:STARt
[SENSe<Ch>:]CORRection:COLLect:FIXTure[:ACQuire]
[SENSe<Ch>:]CORRection:COLLect:FIXTure:SAVE
[SENSe<Ch>:]CORRection:COLLect:FIXTure:EXPort
[SENSe<Ch>:]CORRection:COLLect:FIXTure:IMPort
5.14.3 One Way Loss tab
Defines loss parameters for each physical port.
Use the complementary dock widget to activate or deactivate length/loss compensation
for selected ports (see Chapter 5.14.1.2, "Offset panel", on page 707).
Background information
Refer to the following sections.
●
Chapter 4.6, "Offset parameters and de-/embedding", on page 228
●
Chapter 4.6.1.2, "Definition of loss parameters", on page 229
●
Chapter 4.6.1.4, "Auto Length and Loss", on page 231
●
Chapter 4.6.1.5, "Fixture Compensation", on page 232
Offset Embed softtool
To Next Page
Loading...
