Rohde & Schwarz R&S ZNA Series - 5.14.5.8 EZD Advanced Settings

GUI reference
R&S
®
ZNA
741User Manual 1178.6462.02 ─ 29
Total Port Ordering
Tells the SFD tool about the port ordering of the test fixture
●
"Ports 1&3 on Left" (default): Odd ports are on the left and even ports are on the
right
●
"Ports 1&2 on Left" ports 1 to N are on the left and ports N+1 to 2·N are on the
right
Remote command:
CALCulate:FMODel:SFD:TOTaldiffcfg
Reset to Default
Resets the settings of the "SFD Advanced Settings" to their defaults.
Remote command:
CALCulate:FMODel:SFD:PRESet
5.14.5.8 EZD Advanced Settings
Advanced settings of the EZD tool. For the analyzer firmware, these settings are
global.
Port Order
Tells the EZD tool about the port ordering of the test coupon
●
"Odd on left" (default): Odd ports are on the left and even ports are on the right
●
"1 to N on left" ports 1 to N are on the left and ports N+1 to 2·N are on the right
Remote command:
CALCulate:FMODel:EZD:PORT:ORDer
Generate Side 1/Generate Side2
If checked (default), the tool generates the deembedding file for side 1 / side 2.
Remote command:
CALCulate:FMODel:EZD:GENerate:SIDE<1|2>
Offset Embed softtool