Rohde & Schwarz R&S ZNA Series - 3.3.2.7 Status bar; 3.3.3 Touchscreen gestures

Getting Started
R&S
®
ZNA
54User Manual 1178.6462.02 ─ 29
You can display the "Hard Key" panel using one of the following methods:
●
Select System – [Display] > "View Bar" > "Hard Key Panel".
●
Select "Display"> "View Bar" > "Hard Key Panel On" from the menu bar.
●
Select "Hard Key" from the context menu of the softtool panel.
3.3.2.7 Status bar
The status bar shows
●
the active channel
●
the current channel's sweep averaging counter (e.g. "Ch<i>: Avg 9/10"), or "Ch<i>:
Avg None" if averaging is disabled
●
the progress of the sweep
The progress bar also shows when the R&S ZNA prepares a sweep with new
channel settings
(See Chapter 4.1.4, "Sweep control", on page 110)
●
the "EXT REF" symbol, if an external reference clock is used for synchronization
(see "Ext Frequency" on page 887)
●
a frequency converter symbol, if frequency converters are configured
(see Chapter 5.19.6, "Frequency Converter tab", on page 901)
●
a symbol for redefined S-parameters, if the physical ports have been redefined
(see Chapter 5.19.8.2, "Define Physical Ports dialog", on page 919)
●
the switch matrix status symbol, if a switch matrix is configured
(See Chapter 4.7.41, "External switch matrices", on page 323)
●
the current date and time
Figure 3-5: R&S
ZNA with frequency converters
Figure 3-6: R&S ZNA with switch matrix
The progress bar shows a moving color gradient if the current sweep is too fast to be
monitored, e.g. because the number of sweep points is low. You can hide/show the sta-
tus bar using System – [Display] > "View Bar" > "Status Bar".
3.3.3 Touchscreen gestures
A touchscreen allows you to interact with the software using various finger gestures on
the screen. The basic gestures supported by the software and most applications are
described here. Further actions using the same gestures may be possible.
Operating the instrument