Rohde & Schwarz R&S ZNA Series - User Interface tab

GUI reference
R&S
®
ZNA
860User Manual 1178.6462.02 ─ 29
Delete Cal Pool / Delete All Cal Kits
Deletes all calibration data and all cal kit data. See Chapter 5.11.4.3, "Calibration Man-
ager dialog", on page 638.
Remote command:
n/a
Search Path for additional Cal Kits and Connector Types
Contains the name and path of a special directory for cal kit files (*.calkit). All cal
kit files in the special directory are loaded automatically as predefined kits (i.e. read-
only kits which cannot be modified) every time the VNA application is started. It is pos-
sible to select the default cal kit directory
C:\Users\Public\Documents\Rohde-Schwarz\ZNA\Calibration\Kits or
any other directory. "None" means that no additional cal kit files are loaded on start-up.
Use the special directory to make sure that you do not have to import kits manually,
even after terminating the VNA application improperly. In this case, previously imported
cal kit files are not stored in the recall set file.
Remote command:
MMEMory:LOAD:CKIT:UDIRectory
Interpolation
Selects the algorithm for the interpolation of user system error corrections.
Interpolation is used if the sweep points during the measurement differ from the sweep
points during calibration (state label "Cal int"). Compared to the default linear interpola-
tion, the "Higher Order" (cubic spline) interpolation can slightly slow down the mea-
surement but can provide better results, at least if the measured trace shows no signifi-
cant noise or discontinuities. For the factory system error correction, the analyzer
always uses linear interpolation.
Generally, it is recommended to avoid interpolation whenever possible.
Remote command:
[SENSe:]CORRection:IMEThod
User Interface tab
Provides general user interface configurations.
Setup softtool