GUI reference
R&S
®
ZNA
419User Manual 1178.6462.02 ─ 29
Remote command:
[SENSe<Ch>:]FREQuency:MDELay:RPORt
Delta Frequency
Selects the frequency delta between upper tone and lower tone.
Remote command:
[SENSe<Ch>:]FREQuency:MDELay:APERture
Apply/OK
Applies the settings and activates the group delay measurement mode for the channel
selected in the title bar of the setup dialog.
Remote command:
[SENSe<Ch>:]FREQuency:MDELay:CONVersion
5.3 Format softtool
The "Format" softtool allows you to define how the measured data is presented in the
diagram area.
Access: Trace – [Format]
Measured quantities and display formats
The analyzer allows arbitrary combinations of display formats and measured quantities
(see Chapter 5.2, "Meas softtool", on page 341). Nevertheless, to extract useful infor-
mation from the data, it is important to select a display format which is appropriate to
the analysis of a particular measured quantity.
An extended range of formats is available for markers. To convert any point on a trace,
create a marker and select the appropriate marker format (see "Marker Format"
on page 502). Marker and trace formats can be applied independently.
Background information
Refer to the following sections:
●
Chapter 4.2.3, "Trace formats", on page 140
●
Chapter 4.2.3.3, "Measured quantities and trace formats", on page 148
Format softtool
To Next Page
Loading...
