GUI reference
R&S
®
ZNA
703User Manual 1178.6462.02 ─ 29
If source coherence) and an imbalance sweep is active, this button is disabled. In this
case, the relevant settings can be found in the Coherence Quick Set section.
Source Coh. On
Activates or deactivates the source coherence mode.
If True Differential Mode is active, this button is disabled.
If checked, the main tool bar shows the "Src. Coh." button, with the same functionality
as the Source Coherence... button in the softtool tab.
Remote command:
SOURce<Ch>:CMODe[:STATe]
True Differential Mode
See "True Differential Mode" on page 353.
If Source Coherence is active, this button is disabled.
Coherence Quick Set
This section is only enabled, if Source Coherence and an imbalance sweep is active.
It allows you to specify a reduced set of coherence parameters compared to the
advanced coherence settings of the Source Coherence dialog.
Apply Wave Correction
Same function as "Wave Correction" on page 359.
Remote command:
SOURce<Ch>:CMODe:WCORrection[:STATe]
5.13.3.2 Source Coherence dialog
The "Source Coherence" dialog allows you to enable and configure Phase coherent
source control and True differential mode.
Access:
●
Channel – [Mode] > "Source coherence" tab > "Source Coherence ..."
●
Balanced Ports dialog > "Source Coherence ..."
Mode softtool
To Next Page
Loading...
