Rohde & Schwarz R&S ZNA Series - 7.3.15.8 SOURce:POWer:CORRection:SLEVeling...

Command reference
R&S
®
ZNA
1553User Manual 1178.6462.02 ─ 29
Parameters:
<DeEmbNwType> SENDed | GLOop | OFF | ALL | DIFFerential | PSET | RENorm |
OFFSet | AOFFset
Selects the offset or de-/embedding type to be used, if config-
ured.
ALL means that all available offset and de-/embedding informa-
tion is applied. The <DeEmbType> can be omitted in this case.
*RST: OFF
<DeEmbType> EMBedding | DEEMbedding
Selects between embedding and deembedding for the selected
<DeEmbNwType>.
Must be specified for network types that can be used for embed-
ding and deembedding
Manual operation: See "Embedding" on page 629
7.3.15.8 SOURce:POWer:CORRection:SLEVeling...
The following commands define and control the (source) leveling function that is
enabled with option R&S ZNA-K8.
See Chapter 4.7.7.1, "Leveling", on page 283
SOURce:POWer<PhyPt>:CORRection:SLEVeling[:ACQuire]............................................1553
SOURce:POWer<PhyPt>:CORRection:SLEVeling:DATA:CLEar........................................1554
SOURce:POWer:CORRection:SLEVeling:DATA:CLEar:ALL............................................. 1554
SOURce:POWer<PhyPt>:CORRection:SLEVeling:STATe?...............................................1554
SOURce:POWer<PhyPt>:CORRection:SLEVeling:DELete............................................... 1555
SOURce:POWer<PhyPt>:CORRection:SLEVeling:FREQuency:POINts.............................1555
SOURce<Ch>:POWer<PhyPt>:CORRection:SLEVeling:FREQuency:STARt...................... 1555
SOURce:POWer<PhyPt>:CORRection:SLEVeling:FREQuency:STOP.............................. 1555
SOURce:POWer<PhyPt>:CORRection:SLEVeling:POWer:ALC........................................ 1556
SOURce<Ch>:POWer<PhyPt>:CORRection:SLEVeling:POWer:STARt............................. 1556
SOURce:POWer<PhyPt>:CORRection:SLEVeling:POWer:STOP......................................1556
SOURce:POWer<PhyPt>:CORRection:SLEVeling:POWer:STEP......................................1557
SOURce<Ch>:POWer<PhyPt>:CORRection:SLEVeling:STATe.........................................1557
SOURce:POWer<PhyPt>:CORRection:SLEVeling[:ACQuire]
Starts the leveling data acquisition at port <PhyPt>.
Define the leveling grid using
SOURce<Ch>:POWer<PhyPt>:CORRection:SLEVeling:FREQuency and
SOURce<Ch>:POWer<PhyPt>:CORRection:SLEVeling:POWer commands.
Suffix:
<PhyPt>
.
Physical port number
SCPI command reference