GUI reference
R&S
®
ZNA
402User Manual 1178.6462.02 ─ 29
Background information
Refer to Chapter 4.7.43, "External DLLs", on page 332.
Access: Trace – [Meas] > "S-Params" mode > "External DLL"
5.2.12.1 Controls on the External DLL tab
Configuration / Perm. Settings
Opens the External DLL Configuration Dialog.
Measurement
The "Measurement" section gives access to the custom traces of the loaded plug-ins.
Each external DLL <ext_dll_name>.dll that provides at least one custom trace
type, adds a measurement button "<ext_dll_name>" (with dotted left border) to the
"Measurement" section of the "External DLL" tab. If neither the PAE plugin nor any cus-
tom external DLL is installed, the "Measurement" section is hidden.
Tapping (clicking) or dragging & dropping a measurement button to the diagram area,
opens an additional Trace Definition Dialog.
As usual, tapping (clicking) redefines the current trace while dragging & dropping cre-
ates a trace.
Power Added Efficiency ← Measurement
This button is part of the PAE plugin, which is pre-installed on instruments shipped with
firmware V2.15 or higher, and that can be installed on any instrument running firmware
V2.15 or higher. It opens the Power Added Efficiency (PAE) dialog.
5.2.12.2 External DLL Configuration Dialog
In the "External DLL Configuration" dialog, you can add/remove External DLLs to/from
the firmware. If a plugin requires interaction with an external device, you can define its
address from here.
Meas softtool
To Next Page
Loading...
