Rohde & Schwarz R&S ZNA Series - Page 403

GUI reference
R&S
®
ZNA
403User Manual 1178.6462.02 ─ 29
To add/remove external DLLs, the firmware has to be run as administrator.
(Close the analyzer GUI, tap and hold the "R&S ZNA Vector Network Analyzer" icon on
the desktop and select "Run as administrator"
Loaded DLLs table
Displays the loaded plug-in DLLs and their configuration in the current channel.
Remote command:
[SENSe:]CDLL:LIST?
Active ← Loaded DLLs table
Allows you to de-/activate the respective plugin in the current channel. An active plugin
can be used to create traces and/or can be made Permanent.
Remote command:
[SENSe<Ch>:]CDLL[:STATe]
Permanent ← Loaded DLLs table
Defines the task that is selected via Task Type and further defined via "Additional
Input" on page 403 as permanent.
A permanent task can interact with the firmware, even if it currently does not provide
any traces, e.g. for synchronized control of an external device. In contrast to the trace
mode, the permanent mode of operation is not restricted to a particular driving port.
Remote command:
[SENSe<Ch>:]CDLL:PERManent[:STATe]
Task Type ← Permanent ← Loaded DLLs table
Displays the task types implemented by the external DLL. This combo-box is only
enabled, if the DLL is marked as permanent.
Remote command:
[SENSe<Ch>:]CDLL:PERManent:TASK
Additional Input ← Permanent ← Loaded DLLs table
Specifies additional input that further specifies the permanent task to be performed by
the external DLL.
Meas softtool