Rohde & Schwarz R&S ZNA Series - Page 1326

Command reference
R&S
®
ZNA
1326User Manual 1178.6462.02 ─ 29
[SENSe<Ch>:]CDLL:PERManent:ADDitional.................................................................. 1326
[SENSe<Ch>:]CDLL:PERManent[:STATe]...................................................................... 1327
[SENSe<Ch>:]CDLL:PERManent:TASK......................................................................... 1327
[SENSe:]CDLL:REMove............................................................................................... 1328
[SENSe<Ch>:]CDLL[:STATe].........................................................................................1328
[SENSe<Ch>:]CDLL:TASK:ADDRess............................................................................ 1328
[SENSe:]CDLL:ADD <DllPath>
Tells the analyzer firmware to load a custom (external) DLL.
The DLL and its accompanying files must be packed in a zip archive. It will be loaded
on every subsequent firmware start, until it is removed using [SENSe:]CDLL:REMove
.
Note that adding/removing custom DLLs is only possible if the firmware is run as
administrator.
Setting parameters:
<DllPath> Full path to the zip archive including the DLL (at the top-tevel).
Usage: Setting only
Manual operation: See "Add / Remove" on page 404
[SENSe:]CDLL:LIST?
Queries the loaded custom (external) DLL files.
The return value is a single string, comprising a comma-separated list of DLL names,
without the dll extension.
Use [SENSe:]CDLL:ADD/[SENSe:]CDLL:REMove to load/unload a custom DLL..
Usage:
Query only
Manual operation: See "Loaded DLLs table" on page 403
[SENSe:]CDLL:LIST:TASK? <DllName>
Lists the tasks implemented by the custom (external) DLL <DllName>.
Query parameters:
<DllName> Name of a loaded DLL (see [SENSe:]CDLL:LIST?)
Lowercase string, without dll extension
Usage: Query only
[SENSe<Ch>:]CDLL:PERManent:ADDitional <DllName>, <Additional Input>
[SENSe<Ch>:]CDLL:PERManent:ADDitional? <DllName>
Defines additional input for the task to be run, if custom DLL <DllName> is set to per-
manent mode in channel <Ch> ([SENSe<Ch>:]CDLL:PERManent[:STATe]
'<'DllName>', ON).
SCPI command reference