GUI reference
R&S
®
ZNA
788User Manual 1178.6462.02 ─ 29
Depending on the "Measurement Selection" on page 786 either one, two, or three
channels must be set up:
●
one channel for S-parameter measurements
●
one channel for intermodulation measurements
●
one channel for group delay measurements
Summary
The "Summary" page of the "DUT Centric Wizard"
●
summarizes the channels to be created and the parameters to be measured
●
allows you where to define these channels (new setup, append to current setup,
replace current setup)
●
allows you to decide whether to proceed with a (suitable) calibration
Calibrate Newly Created Channels
If you finish the "DUT Centric Wizard" with "Calibrate Newly Created Channels"
selected, then, after creating the required (setup and) channels, the FW will proceed
with suitable calibrations.
DUT softtool
To Next Page
Loading...
