Rohde & Schwarz R&S ZNA Series - 5.19.1.2 System Config dialog; Presets tab

GUI reference
R&S
®
ZNA
856User Manual 1178.6462.02 ─ 29
5.19.1.2 System Config dialog
The "System Config" dialog allows you to define global settings that are not affected by
an instrument reset. See Chapter 4.1.1, "Global (persistent) settings", on page 107.
Access: System – [Setup] > "Setup" > "System Config..."
● Presets tab............................................................................................................856
● Calibration tab.......................................................................................................858
● User Interface tab..................................................................................................860
● Messages tab........................................................................................................863
● Channel Bits tab....................................................................................................864
● Advanced tab........................................................................................................ 865
● Power tab..............................................................................................................867
● Recovery tab.........................................................................................................870
● HUMS tab..............................................................................................................871
Presets tab
Specifies the behavior of the R&S ZNA upon a preset.
Setup softtool