GUI reference
R&S
®
ZNA
757User Manual 1178.6462.02 ─ 29
Remote command:
n.a.
Balanced Ports
Opens the Balanced Ports dialog.
5.14.11.2 Deembedding Assistant dock widget panel
The two pages of the "Offset Embed" dock widget's "Deembedding Assistant" panel
allow you to model your DUT and its test fixture, to collect the input data for the
selected fixture tool, to run the tool, and to apply the calculated deembedding.
Access: Channel – [Offset Embed] > "Deembed Assistant" tab
(click the tab to reopen)
Page 1: Topology
The first page of the "Deembedding Assistant" defines the deembedding topology. It
allows you to describe your device under test (DUT) in terms of inputs, outputs, and
the test coupons required to model the DUT's fixture.
Depending on the selected fixture tool, it narrows down the selectable DUT types and
test coupon models.
DUT
The first step in setting up a new deembedding with the "Deembedding Assistant" is to
select the type of DUT. Depending on the number of available test/DUT ports and the
selected fixture tool, choose one of the following DUT types:
Table 5-10: DUT types
DUT type Description ISD only
"1 x 1 Single Ended" 1 single-ended input, 1 single-ended output
"1 x Single Ended" 1 single-ended input, no output
Offset Embed softtool
To Next Page
Loading...
