Rohde & Schwarz R&S ZNA Series - Page 758

GUI reference
R&S
®
ZNA
758User Manual 1178.6462.02 ─ 29
DUT type Description ISD only
"1 x 1 Balanced" 1 balanced input, 1 balanced output 
"1 x Balanced" 1 balanced input, no output 
"1 x Balanced, 1 x Single Ended" 1 balanced input, 1 single-ended output
☑
"2 x 1 Single Ended" 2 single-ended inputs, 1 single-ended output
☑
"2 x 2 Single Ended" 2 single-ended inputs, 2 single-ended outputs
☑
"n x Single Ended" n single-ended inputs, no outputs
☑
"n x m Single Ended" n single-ended inputs, m single-ended outputs
☑
"n x Balanced" n balanced inputs, no outputs
☑
"n x m Balanced" n balanced inputs, m balanced outputs
Currently not supported
☑
The dock widget presents a graphical representation of the selected "DUT" and cou-
pon models, e.g. for a "1 x 1 Balanced" DUT witch "Balanced " left and right models:
Remote command:
CALCulate:FMODel:DEASsistant:DUT:TYPE
CALCulate:FMODel:DEASsistant:PRESet
Left: Model A / Right: Model A|B
Allows you to select a coupon type, i.e. to define how the coupling at the left side (lead-
in) and right side (lead-out) of the DUT is modeled.
If you select the same model for the left and right side and check "Use Same Coupon
Left and Right" on page 760, then also the right side is labeled with "Model A" and in
the measurement phase only the data of a single coupon ("Coupon A") must be mea-
sured or loaded from file.
Offset Embed softtool