GUI reference
R&S
®
ZNA
759User Manual 1178.6462.02 ─ 29
"Single Ended"
This coupon model is appropriate for one or more single-ended inputs
(outputs), where:
●
All inputs (outputs) use the same coupon model and
●
There is no interaction between inputs (outputs) if more than one
is present on the DUT
Figure 5-48: n single-ended input ports (uncoupled)
"Balanced"
This coupon type is appropriate for one or more balanced inputs (out-
puts), if:
●
All inputs (outputs) use the same coupon model and
●
There is no interaction between inputs (outputs) if more than one
is present on the DUT
Figure 5-49: n balanced input ports
"Uncoupled"
This coupon type selection is available only for balanced ports on the
DUT. It is used for deembedding a balanced port when it is desired to
treat the single-ended legs of the port as uncoupled entities.
Figure 5-50: n uncoupled balanced input ports
Offset Embed softtool
To Next Page
Loading...
