Rohde & Schwarz R&S ZNA Series - Page 760

GUI reference
R&S
®
ZNA
760User Manual 1178.6462.02 ─ 29
"Coupled"
This coupon type is available for DUTs with two or more single-ended
or balanced inputs (outputs). It is suitable for a multiport DUT with
coupled inputs (outputs) that have to be deembedded as a single
unit.
Coupled coupons are drawn with a brace to highlight the difference
between coupled and uncoupled ports.
Figure 5-51: n > 1 coupled input ports (single-ended | balanced)
Remote command:
CALCulate:FMODel:DEASsistant<Ph_pt>:FIXTure:LEFT:TYPE
CALCulate:FMODel:DEASsistant:FIXTure:RIGHt:TYPE
CALCulate:FMODel:DEASsistant:PRESet
Use Same Coupon Left and Right
This control is only active, if you selected a two-sided DUT and the same coupon
model for the left and right side.
If checked, then in the measurement phase only the data of a single coupon ("Coupon
A") must be measured or loaded from file.
Remote command:
CALCulate:FMODel:DEASsistant:SAMCoupon
CALCulate:FMODel:DEASsistant:PRESet
Remove Active Deembedding
Use this button to remove the fixture deembedding and to deactivate all other deem-
bedding in the active channel (see"All Deembedding Activated" on page 726).
Note that the "Deembedding Assistant" works slightly different than the legacy Fixture
modeling dialog. In the "Deembedding Assistant", once applied, the deembedding
remains active until cleared or (partly) overwritten. The "Fixture Modeling" dialog resets
all deembedding files of a specific type (single-ended, balanced, port set), every time
you press the "Apply" button.
Overview
This button takes you to the Overview panel of the "Offset Embed" dock widget, which
allows you to interact with the individual components of the deembedding calculation
chain.
To reopen the "Deembedding Assistant" panel, you have to click/tap on the "Deembed
Assistant" tab caption once again.
<Tool> Advanced Settings
Opens the "Advanced Settings" dialog of the selected fixture tool:
●
Chapter 5.14.5.6, "ISD Advanced Settings", on page 736
●
Chapter 5.14.5.7, "SFD Advanced Settings", on page 740
Offset Embed softtool