Rohde & Schwarz R&S ZNA Series

To Next Page

To Previous Page

GUI reference

R&S

ZNA

726User Manual 1178.6462.02 ─ 29

All Deembedding Activated

Deactivates or activates all deembeddings (single-ended, balanced, port set, ground

loop) for the active channel, if any.

This control is only visible if Type = "Deembedding".

Remote command:

n.a.

Network

The graphical list contains all available 2-port networks:

●

The

symbol selects "no network" and disables single-ended de-/embedding.

●

The "2-Port Data" network is defined by means of an s2p file (see Select File...).

For deembedding, the s2p file can also be generated by a third-party fixture model-

ing tool (see "Fixture Tool" on page 727).

●

The remaining networks are defined by lumped elements. Their parameters are

displayed below the graphical list.

Tip: Drag and drop the network symbols in horizontal or vertical direction to switch to

the next symbol. The lumped elements are numbered from top to bottom.

Remote command:

CALCulate<Ch>:TRANsform:VNETworks:SENDed:DEEMbedding<PhyPt>[:

STATe]

CALCulate<Ch>:TRANsform:VNETworks:SENDed:DEEMbedding<PhyPt>:

TNDefinition

CALCulate<Ch>:TRANsform:VNETworks:SENDed:DEEMbedding<PhyPt>:

PARameters:C<Cmp>

CALCulate<Ch>:TRANsform:VNETworks:SENDed:DEEMbedding<PhyPt>:

PARameters:G<Cmp>

CALCulate<Ch>:TRANsform:VNETworks:SENDed:DEEMbedding<PhyPt>:

PARameters:L<Cmp>

CALCulate<Ch>:TRANsform:VNETworks:SENDed:DEEMbedding<PhyPt>:

PARameters:R<Cmp>

CALCulate<Ch>:TRANsform:VNETworks:SENDed:EMBedding<PhyPt>[:

STATe]