Rohde & Schwarz R&S ZNA Series - CALCulate:TRANsform:TIME...

Command reference
R&S
®
ZNA
1136User Manual 1178.6462.02 ─ 29
See also CALCulate<Chn>:TRANsform:DTFault:CENTer and
CALCulate<Chn>:TRANsform:DTFault:SPAN.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Start>/<Stop> Start/stop distance.
Default unit: m
Example:
:CALCulate1:TRANsform:DTFault:STARt 1; STOP 3
Defines the DtF distance window of the active trace of channel 1
as [1m, 3m].
Options: R&S ZNA-K2
Manual operation: See "Start Distance / Stop Distance" on page 832
CALCulate<Chn>:TRANsform:DTFault:STATe
<DtfState>
If channel <Chn> is performing an unsegmented frequency sweep, this command
allows to transform its active trace into a Distance to Fault (DtF) trace.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<DtfState> OFF|ON – DtF disabled|enabled
*RST: OFF
Example:
:CALCulate1:TRANsform:DTFault:STATE ON
turns the DtF representation of the active trace of channel 1 ON.
Options: R&S ZNA-K2
Manual operation: See "Distance to Fault" on page 831
CALCulate:TRANsform:TIME...
The CALCulate:TRANsform:TIME... commands control the transformation into the
time domain (see Chapter 4.7.2, "Time domain analysis", on page 247).
CALCulate<Chn>:TRANsform:TIME:CENTer.................................................................. 1137
CALCulate<Chn>:TRANsform:TIME:DCHebyshev...........................................................1137
CALCulate<Chn>:TRANsform:TIME:LPASs.................................................................... 1138
CALCulate<Chn>:TRANsform:TIME:LPASs:DCSParam...................................................1138
CALCulate<Chn>:TRANsform:TIME:LPASs:DCSParam:CONTinuous............................... 1139
CALCulate<Chn>:TRANsform:TIME:LPASs:DCSParam:EXTRapolate...............................1139
CALCulate<Chn>:TRANsform:TIME:LPFRequency......................................................... 1140
CALCulate<Chn>:TRANsform:TIME:RESolution:EFACtor................................................ 1140
CALCulate<Chn>:TRANsform:TIME:SPAN..................................................................... 1140
CALCulate<Chn>:TRANsform:TIME:STARt.................................................................... 1141
CALCulate<Chn>:TRANsform:TIME:STATe.....................................................................1141
CALCulate<Chn>:TRANsform:TIME:STIMulus................................................................ 1142
SCPI command reference