GUI reference
R&S
®
ZNA
702User Manual 1178.6462.02 ─ 29
Remote command:
CONTrol:VSE:ADDRess
Save VSE Configuration
If a connection to a R&S VSE instance is established, you can download its current
configuration and save it to a file on the R&S ZNA.
Remote command:
CONTrol:VSE:CONFig:SAVE
Load VSE Configuration
If a connection to a R&S VSE instance is established, you can load its configuration
from a file on the R&S ZNA (previously created using Save VSE Configuration).
Remote command:
CONTrol:VSE:CONFig:LOAD
5.13.3 Source Coherence tab
The "Source Coherence" tab allows you to configure source signals with defined
phase.
Source coherent signals require the Phase coherent source control option R&S ZNA-
K6. If this option is not equipped, the "Source Coherence" tab is not available.
5.13.3.1 Controls on the Source Coherence tab
Source Coherence...
Opens the Source Coherence dialog.
Mode softtool
To Next Page
Loading...
