GUI reference
R&S
®
ZNA
701User Manual 1178.6462.02 ─ 29
Start/Connect VSE / Disconnect VSE
Select your target R&S VSE using Local VSE or the VISA address list. Then use the
"Start/Connect VSE" button to connect to it and to start its pulse measurements appli-
cation (R&S VSE-K6 ). A local R&S VSE is started automatically.
Once the connection is established, you can use "Disconnect VSE" to terminate it.
Remote command:
CONTrol:VSE:CONNect
CONTrol:VSE:DISConnect
Local VSE
Tells the R&S ZNA that you want to connect to a local R&S VSE. Use Start/Connect
VSE / Disconnect VSE to establish the connection.
Remote command:
CONTrol:VSE:LOCal
Scan LAN
Scans the LAN for VISA resources (VISA auto-discovery).
VISA address list
A list of known VISA addresses, populated using Scan LAN and extended manually.
If you do not want to connect to a Local VSE, mark the address of your remote target
R&S VSE as "Active" and select Start/Connect VSE / Disconnect VSE.
Remote command:
CONTrol:VSE:ADDRess
Set Address Manually/Apply Address
Allows you to specify the VISA address of a remote target R&S VSE manually.
"Apply Address" adds the specified address to the VISA address list. Manually added
addresses are stored in the active R&S ZNA setup.
Mode softtool
To Next Page
Loading...
