Getting Started
R&S
®
ZNA
80User Manual 1178.6462.02 ─ 29
Intended use
Rohde & Schwarz vector network analyzers and millimeterwave converters
R&S ZNA67EXT are intended for the development, production and verification of elec-
tronic components and devices in industrial, administrative, and laboratory environ-
ments. Only use them for their designated purpose. Observe the operating conditions
and performance limits stated in the data sheet.
Where do I find safety information?
Safety information is part of the product documentation. It warns you of potential dan-
gers and gives instructions on how to prevent personal injury or damage caused by
dangerous situations. Safety information is provided as follows:
●
Multilingual safety information is provided in the printed Getting Started guide of
the R&S ZNA67EXT, and delivered with the system's R&S ZNA67.
●
Throughout the documentation, safety instructions are provided when you need to
take care during setup or operation.
3.5.1.1 Labels on the external test sets
Labels on the frequency converters and diplexers inform about:
●
Product and environment safety
●
Identification of the product
Table 3-6: Labels regarding product and environment safety
Labeling in line with EN 50419 for disposal of electrical and electronic equipment after the prod-
uct has come to the end of its service life. For more information, see "Disposing electrical and
electronic equipment" on page 1773.
Take care when handling electrostatic sensitive devices.
3.5.1.2 Warning messages in the documentation
A warning message points out a risk or danger that you need to be aware of. The sig-
nal word indicates the severity of the safety hazard and how likely it will occur if you do
not follow the safety precautions.
NOTICE
Potential risks of damage. Could result in damage to the supported product or to other
property.
Getting started with R&S
ZNA67EXT
To Next Page
Loading...
