GUI reference
R&S
®
ZNA
635User Manual 1178.6462.02 ─ 29
Background information
Refer to the following sections:
●
Chapter 4.5, "Calibration", on page 186
5.11.4.1 Controls on the Use Cal tab
User Cal Active
Activates or deactivates the system error correction in the active channel. "User Cal
Active" is available only if a valid system error correction is available for the active
channel; see "Channel State" in Chapter 5.11.4.3, "Calibration Manager dialog",
on page 638.
Note: A label "Cal Off" appears behind the trace list if the system error correction is
switched off; see also Chapter 4.5.4, "Calibration labels", on page 206. The calibration
status of each channel and trace appears in the setup information ("Setup" > "Info..." >
"Setup").
Remote command:
[SENSe<Ch>:]CORRection[:STATe]
Cal softtool
To Next Page
Loading...
