GUI reference
R&S
®
ZNA
350User Manual 1178.6462.02 ─ 29
5.2.2.3 More S-Params dialog
Allows to select an arbitrary S-parameter as measured quantity, along with a suitable
Detector.
Access: Trace – [Meas] > "S-Params" > "More S-Params..."
S-Parameter
See "S-Parameter (selector)" on page 345.
Detector
Selects the algorithm that is used to calculate the results points from the raw measure-
ment data.
For details refer to Chapter 4.3.5.3, "Detector settings", on page 160.
Remote command:
CALCulate<Ch>:PARameter:MEASure
CALCulate<Ch>:PARameter:SDEFine
[SENSe<Ch>:]SWEep:DETector:TIME
5.2.2.4 Imbalance Differential dialog
Allows you to measure the differential mode imbalance of a DUT with balanced input
and output ports, connected to a balanced and two single-ended logical ports at the
VNA.
Access: Trace – [Meas] > "S-Params" > "Y/Z/k/μ-Parameters": "Imbalance/CMRR" >
"Imbalance Differential..."
Meas softtool
To Next Page
Loading...
