Rohde & Schwarz R&S ZNA Series - 7.3.17.2 SYSTem:... (other)

Command reference
R&S
®
ZNA
1629User Manual 1178.6462.02 ─ 29
SYSTem:COMMunicate:RDEVice:SMATrix<Matr>:RELays:SWITch:COUNt?
For mechanical matrices, this command allows to query the list of switch counts for all
relays (if supported by the matrix).
Suffix:
<Matr>
.
Index of the switch matrix (see SYSTem:COMMunicate:
RDEVice:SMATrix<Matr>:DEFine on page 1627)
Usage: Query only
Manual operation: See "Configured External Switch Matrices" on page 878
SYSTem:COMMunicate:RDEVice:SMATrix:SCAN?
Scans for external switch matrices connected via USB.
Returns a comma-separated list
<Driver_1>,<Interface_1>,<Address_1>,...,<Driver_N>,
<Interface_N>,<Address_N>, one triple
<Driver_n>,<Interface_n>,<Address_n> for each detected switch matrix
<Matr>=1,...,N.
Use SYSTem:COMMunicate:RDEVice:SMATrix<Matr>:DEFine to configure them.
Usage:
Query only
Manual operation: See "Scan Instruments" on page 911
SYSTem:COMMunicate:RDEVice:SMATrix<Matr>:SERial?
Returns the serial number of the related switch matrix.
Suffix:
<Matr>
.
Index of the switch matrix (see SYSTem:COMMunicate:
RDEVice:SMATrix<Matr>:DEFine on page 1627)
If the switch matrix is not part of the RF configuration, the query
returns an "Invalid suffix" error.
Usage: Query only
Manual operation: See "Configured Devices" on page 911
7.3.17.2 SYSTem:... (other)
The following SYSTem... commands provide general instrument configurations.
SYSTem:AGC:GLOBal:METHod....................................................................................1631
SYSTem:CORRection:JOINcal...................................................................................... 1631
SYSTem:CORRection:WIZard[:IMMediate]..................................................................... 1632
SYSTem:DATE............................................................................................................ 1632
SYSTem:DFPRint?.......................................................................................................1632
SYSTem:DISPlay:BAR:HKEY[:STATe]............................................................................1632
SCPI command reference