Rohde & Schwarz R&S ZNA Series - Page 1632

Command reference
R&S
®
ZNA
1632User Manual 1178.6462.02 ─ 29
Manual operation: See "Input Calibration1/Input Calibration2/Cal Name"
on page 642
SYSTem:CORRection:WIZard[:IMMediate] <Dialogs>
Keysight-compatible command to open the Start Cal tab or the Calibration Kits dialog.
Tip: When working with the Chapter 6.1.3, "GPIB Explorer", on page 933, switch to
raw mode ("Options">"Raw mode" in the IECWIN32 GUI) before executing this com-
mand.
Setting parameters:
<Dialogs> MAIN | CKIT
MAIN: open the "Calibration > Start Cal" softtool tab
CKIT: open the "Calibration Kits" dialog
Usage: Setting only
SYSTem:DATE <Year>, <Month>, <Day>
The command queries or defines the instrument's current date setting.
The setting command requires administrator rights; refer to "User accounts and pass-
word protection" on page 30.
Parameters:
<Year> Year, four-digit number
<Month> Month, two-digit number, 01 (for January) to 12 (for December)
<Day> Day, two-digit number, 01 to the number of days in the month
Example:
SYST:DATE?
Response: 2012,05,01 - it is the 1st of May, 2012.
SYSTem:DFPRint?
Queries the device footprint. The device footprint contains detailed information about
the instrument and is mostly used for service purposes.
Usage:
Query only
Manual operation: See "Save..." on page 874
SYSTem:DISPlay:BAR:HKEY[:STATe] <Boolean>
SYSTem:DISPlay:BAR:MENU[:STATe] <Boolean>
SYSTem:DISPlay:BAR:STATus[:STATe] <Boolean>
SYSTem:DISPlay:BAR:STOols[:STATe] <Boolean>
SCPI command reference