Rohde & Schwarz R&S ZNA Series - 7.3.3 CONTrol commands

Command reference
R&S
®
ZNA
1210User Manual 1178.6462.02 ─ 29
CONFigure:TRACe:WINDow:TRACe? <TraceName>
Returns the number of the diagram which the trace <TraceName> is assigned to. A
zero is returned when the trace is not assigned/displayed.
The diagram number is equal to the <Wnd> suffix in DISPlay[:WINDow<Wnd>]:
TRACe<WndTr>:FEED and similar commands; see example.
Query parameters:
<TraceName> Trace name (string), e.g. 'Trc1'
Example:
*RST; :CALC:PAR:SDEF 'Trc2', 'S11'
Create a trace named Trc2.
CONF:TRAC:WIND:TRAC? 'Trc2'
Query the diagram number for Trc2. The new trace is not dis-
played, so the response is 0.
DISP:WIND2:STAT ON
Create a diagram no. 2.
DISP:WIND2:TRAC3:FEED 'Trc2'
Display the trace in the new diagram no. 2, assigning the trace
number 3.
CONF:TRAC:WIND? 'Trc2'
Query the diagram number for Trc2. The response is 2.
CONF:TRAC:WIND:TRAC? 'Trc2'
Query the trace number for Trc2. The response is 3.
Usage:
Query only
Manual operation: See "Table Area" on page 435
7.3.3 CONTrol commands
The Control... commands allow you to configure the following interfaces:
●
User Port
●
External Handler I/O (Universal Interface, option R&S ZNBT-Z14)
●
RFFE GPIO interface (option R&S ZNA-B15)
●
R&S VSE (see Chapter 4.7.6.1, "Live pulse analysis with R&S VSE", on page 280
CONTrol:AUXiliary:C[:DATA]......................................................................................... 1212
CONTrol<Ch>:GPIO<Port>:RANGe...............................................................................1213
CONTrol:GPIO<Port>:SENSe:CURRent?.......................................................................1214
CONTrol:GPIO:SENSe:SUMCurrent?............................................................................ 1214
CONTrol<Ch>:GPIO:SENSe:TRIGger............................................................................1214
CONTrol:GPIO<Port>:SENSe:VOLTage?....................................................................... 1215
CONTrol<Ch>:GPIO<Port>:SHUNt?.............................................................................. 1215
CONTrol<Ch>:GPIO<Port>[:STATe]............................................................................... 1216
CONTrol<Ch>:GPIO:TIME............................................................................................ 1217
CONTrol<Ch>:GPIO<Port>:VOLTage[:DEFault].............................................................. 1217
CONTrol<Ch>:GPIO:VOLTage:OUTPut..........................................................................1217
CONTrol<Ch>:RFFE<Bus>:COMMand:DATA................................................................. 1218
SCPI command reference