Rohde & Schwarz R&S ZNA Series - Page 1215

Command reference
R&S
®
ZNA
1215User Manual 1178.6462.02 ─ 29
Manual operation: See "Meas" on page 664
CONTrol:GPIO<Port>:SENSe:VOLTage? [<ALL>]
Returns the results of the voltage measurement on the related GPIO pin or ALL GPIO
pins.
Suffix:
<Port>
.
GPIO port number.
If ALL voltages are queried, this suffix is ignored and can be
omitted.
Query parameters:
<ALL> ALL
Use ALL to measure the voltages at all GPIO pins.
Return values:
<Results> Measured voltages, either a single value or a comma-separated
list.
Default unit: V
Usage: Query only
Options: R&S ZN-B15/Z15 Var. 03
Manual operation: See "Voltage, Current" on page 665
CONTrol<Ch>:GPIO<Port>:SHUNt?
Returns the shunt resistance (in Ω) selected by the analyzer firmware for the config-
ured current range (see CONTrol<Ch>:GPIO<Port>:RANGe).
The dependency between current range and shunt resistance is displayed in the tables
below.
Note: The high resistance configuration of pins 9 and 10 requires FPGA version 6.1.0
or higher. For older versions of the R&S ZN-B15/Z15 Var. 03, pins 9 and 10 have the
same current range as pins 1 to 8.
Suffix:
<Ch>
.
Channel number
<Port> GPIO port 1, ..., 10
SCPI command reference