Rohde & Schwarz R&S ZNA Series - GPIO voltage and current measurements

GUI reference
R&S
®
ZNA
663User Manual 1178.6462.02 ─ 29
Figure 5-30: Basic GPIO Configuration for HW Var. 03
Seq.
Enables/disables the corresponding GPIO pin in the Sweep Sequencer (see Chap-
ter 5.12.1.6, "Sweep Sequencer", on page 665).
Remote command:
CONTrol<Ch>:GPIO<Port>[:STATe]
Voltage / Output Voltage
Sets the (default) voltage of the respective GPIO pin for R&S ZN-B15/-Z15 Var. 02 /
Var. 03.
Remote command:
CONTrol<Ch>:GPIO<Port>:VOLTage[:DEFault]
Apply
Use the "Apply" button to activate the configured voltage (and Range / Shunt) settings
to the GPIO pins.
Remote command:
CONTrol<Ch>:GPIO:VOLTage:OUTPut
GPIO voltage and current measurements
Defines and executes the voltage and current measurements on the GPIO pins.
Channel Config softtool