Rohde & Schwarz R&S ZNA Series - Page 1209

Command reference
R&S
®
ZNA
1209User Manual 1178.6462.02 ─ 29
CONFigure:TRACe<Trc>:NAME:ID? <TraceName>
Queries the trace number (numeric suffix) of a trace with known trace name.
CONFigure:TRACe:CATalog? returns a list of all traces in the active recall set with
their names.
Suffix:
<Trc>
.
Trace number. This suffix is not relevant and may be omitted
(the command returns the actual trace number).
Query parameters:
<TraceName> Trace name, e.g. 'Ch2Trc2'.
Example: See CONFigure:TRACe:CATalog?
Usage: Query only
CONFigure:TRACe<Trc>:REName
<OldTraceName>, <NewTraceName>
Assigns a new name to a trace. The trace does not have to be the active trace.
Suffix:
<Trc>
.
Trace number. This suffix is ignored; the trace is identified via its
<TraceName>
Setting parameters:
<OldTraceName> String parameter with old trace name, e.g. 'Trc1'
<NewTraceName> String parameter with new trace name, e.g. 'S11 Trace'
*RST: n/a
Example: See CONFigure:CHANnel<Ch>:TRACe:REName
Usage: Setting only
Manual operation: See "Table Area" on page 435
CONFigure:TRACe:WINDow? <TraceName>
Returns the trace number within a diagram which is assigned to the trace
<TraceName> is assigned to. A zero is returned when the trace is not assigned/
displayed.
The trace number is equal to the <WndTr> suffix in DISPlay[:WINDow<Wnd>]:
TRACe<WndTr>:FEED and similiar commands; see example.
Query parameters:
<TraceName> Trace name (string), e.g. 'Trc1'
Example: See CONFigure:TRACe:WINDow:TRACe?
Usage: Query only
SCPI command reference