Rohde & Schwarz R&S ZNA Series - Page 1208

Command reference
R&S
®
ZNA
1208User Manual 1178.6462.02 ─ 29
CONFigure:TRACe<Trc>:CHANnel:NAME? <TraceName>
Queries the channel name for an existing trace named '<TraceName>'.
Suffix:
<Trc>
.
Trace number. This suffix is ignored; the trace is referenced by
its name.
Query parameters:
<TraceName> Trace name, e.g. 'Ch2Trc2'.
Example: See CONFigure:TRACe:CATalog?
Usage: Query only
Manual operation: See "New Channel" on page 654
CONFigure:TRACe<Trc>:CHANnel:NAME:ID?
<TraceName>
Queries the channel number (numeric suffix) for an existing trace named
'<TraceName>'.
Suffix:
<Trc>
.
Trace number. This suffix is ignored; the trace is referenced by
its name.
Query parameters:
<TraceName> Trace name, e.g. 'Ch2Trc2'.
Example: See CONFigure:TRACe:CATalog?
Usage: Query only
Manual operation: See "New Channel" on page 654
CONFigure:TRACe<Trc>:NAME <TraceName>
Assigns a name to an existing trace number <Trc>. Note that it is not possible to
assign the same name to two different traces. CONFigure:TRACe:CATalog? returns
a list of all traces in the active recall set with their names.
Suffix:
<Trc>
.
Number of an existing trace.
Parameters:
<TraceName> Trace name, e.g. 'Ch2Trc2'.
*RST: 'Trc1'
Example: See CONFigure:TRACe:CATalog?
SCPI command reference