Rohde & Schwarz R&S ZNA Series - Page 1036

Command reference
R&S
®
ZNA
1036User Manual 1178.6462.02 ─ 29
OFF (0)
Port <Ph_pt> not connected
Options: R&S ZNA-K210
Manual operation: See "Active" on page 733
CALCulate:FMODel:EZD:GENerate:SIDE<1|2> <Boolean>
Tells the EZD tool to create fixture deembedding data at side 1, at side 2, or at both
sides.
Suffix:
<1|2>
.
Side
Parameters:
<Boolean> ON (1)
Create fixture deembedding data at the specified side (<1|2>)
OFF (0)
Do not create fixture deembedding data at the specified side
(<1|2>)
Options: R&S ZNA-K210
Manual operation: See "Generate Side 1/Generate Side2" on page 741
CALCulate:FMODel:EZD:IMPedance <Boolean>
Switches the impedance correction of the EZD tool ON or OFF. Its reference impe-
dance and bandwidth limit parameters can be set using CALCulate:FMODel:EZD:
IMPedance:REFerence and CALCulate:FMODel:EZD:IMPedance:BWIDlimit,
respectively.
This is a global setting.
Parameters:
<Boolean> ON (1) or OFF (0)
Options: R&S ZNA-K210
Manual operation: See "Use Impedance Correction" on page 730
CALCulate:FMODel:EZD:IMPedance:BWIDlimit <Value>
Defines the "Bandwidth Limit" parameter of the EZD tool's impedance correction (see
CALCulate:FMODel:EZD:IMPedance.
Parameters:
<Value> Default unit: Hz
Options: R&S ZNA-K210
Manual operation: See "Impedance Correction Settings" on page 742
SCPI command reference