Rohde & Schwarz R&S ZNA Series - Page 1231

Command reference
R&S
®
ZNA
1231User Manual 1178.6462.02 ─ 29
DIAGnostic:PRODuct:OPTion:INFO? <Option>, <Detail>
Queries a property of an installed software option, identified by its name.
Query parameters:
<Option> Option name, e.g. 'ZNA-K2'.
<Detail> DESCription | TYPE | ACTivation | EXPiration | KEY
You can query for an option's DESCription, its KEY and key
TYPE, and its ACTivation and EXPiration date (if applicable).
Example:
DIAGnostic:PRODuct:OPTion:INFO? 'ZNA-K2',DESC
On a R&S ZNA this returns 'Time Domain Analysis' (if
installed).
Usage: Query only
Manual operation: See "Software Option Info" on page 877
DIAGnostic:SERVice:RFPower
<Boolean>
Turns the internal source power at all ports and the power of all external generators on
or off. This command is equivalent to OUTPut<Ch>[:STATe] .
Parameters:
<Boolean> ON | OFF - switch the power on or off.
*RST: ON
Example:
DIAG:SERV:RFP OFF
Turn off the RF source power.
DIAGnostic:SERVice:SFUNction <SFIdentifier>
Calls a service function (mainly for internal use).
●
Use SYSTem:PASSword[:CENable] to activate the required service level.
●
Use the query form to read back the data returned by the service function.
Parameters:
<SFIdentifier> Service function in "dotted textual" (example: 'sw.common.mem-
ory_usage') or "dotted decimal" (example: '0.1.18.0') representa-
tion.
Example:
DIAGnostic:SERVice:SFUNction?
'sw.common.memory_usage'
This is an "Info Level" service function, i.e. it is not password-
protected. It returns the curent memory usage of the analyzer
firmware.
Manual operation: See "Service Function" on page 886
SCPI command reference