Rohde & Schwarz R&S ZNA Series - Page 1314

Command reference
R&S
®
ZNA
1314User Manual 1178.6462.02 ─ 29
OUTPut<Ch>[:STATe]...................................................................................................1314
OUTPut[:STATe]:TYPE................................................................................................. 1314
OUTPut:ULED:STATe...................................................................................................1314
OUTPut:UPORt:ECBits.................................................................................................1315
OUTPut<Ch>:UPORt:SEGMent<Seg>:STATe.................................................................1315
OUTPut<Ch>:UPORt:SEGMent<Seg>[:VALue]...............................................................1315
OUTPut<Ch>:UPORt[:VALue]....................................................................................... 1317
OUTPut<Ch>[:STATe] <Boolean>
Turns the internal source power at all ports and the power of all external generators on
or off.
Suffix:
<Ch>
.
Channel number. This suffix is ignored; the setting is valid for all
channels.
Parameters:
<Boolean> ON | OFF - switch the power on or off.
*RST: ON
Example:
OUTP OFF
Turn off the RF source power.
Manual operation: See "RF Off All Channels" on page 526
OUTPut[:STATe]:TYPE <OutputTypeMode_Descript>
Allows you to define how the R&S ZNA turns the RF power off.
Parameters:
<OutputTypeMode_Descript>FAST | LBNoise
FAST
Only the RF switch is used (default).
LBNoise
In addition to the switches, all amplifiers are turned off. Results
in lower broadband noise.
Manual operation: See "RF Off Behavior" on page 870
OUTPut:ULED:STATe <ledState>
Configures the "User Defined" LED at the front panel of the R&S ZNA. This is a persis-
tent setting.
Parameters:
<ledState> OFF | GREen | RED | FGReen | FRED
OFF
Switched off
GREen
Green color, permanently on
SCPI command reference