Rohde & Schwarz R&S ZNA Series - Page 1522

Command reference
R&S
®
ZNA
1522User Manual 1178.6462.02 ─ 29
Manual operation: See "Use Port Match and Calibration" on page 704
SOURce<Ch>:CMODe:PORT<Pt>:PHASe <Value>
Defines the phase (or phase start) for the coherent signal at port no. <PhyPt>.
Use SOURce<Ch>:CMODe:PORT<Pt>:PHASe:SPAN to set the phase span.
Suffix:
<Ch>
.
Channel number. If unspecified the numeric suffix is set to 1.
<Pt> Physical port number
Parameters:
<Value> Port-specific phase value
Increment: 1-deg
*RST: 0 deg
Example: See SOURce<Ch>:CMODe:PORT<Pt>[:STATe] on page 1522
Options: R&S ZNA-K6
Manual operation: See "Phase Start" on page 704
SOURce<Ch>:CMODe:PORT<Pt>:PHASe:SPAN <Value>
Sets the phase span for port <Pt> in channel <Ch>, if source coherence is enabled
Use amplitude imbalance sweep SOURce<Ch>:CMODe:PORT<Pt>:PHASe to set the
start phase.
Does not apply if an imbalance sweep is running.
Suffix:
<Ch>
.
Channel number
<Pt> Port number
Parameters:
<Value> Phase span in degrees
Options: R&S ZNA-K6
Manual operation: See "Phase Span" on page 705
SOURce<Ch>:CMODe:PORT<Pt>[:STATe] <Boolean>
Enables or disables defined phase coherence at physical port <Pt> for channel <Ch>.
The target phase is defined using SOURce<Ch>:CMODe:PORT<Pt>:PHASe.
Suffix:
<Ch>
.
Channel number
<Pt> Physical port number
SCPI command reference